Aei Dk 9830 Change Password !full! -

Press the key (This selects the operation mode for "Card or PIN"). Enter the New User Password (4 to 8 digits). Press the # key to save the code.

Press: [user slot number] [new user code] # aei dk 9830 change password

If you inherit a property or forget the master code, you cannot enter programming mode using standard methods. To resolve this, you must reset the master code using the internal reset jumper on the circuit board: Disconnect the power supply from the keypad. Press the key (This selects the operation mode

(Direct Access to Programming) on the board and move it from the : Reconnect the power. The internal buzzer will sound. Reset Jumper : Move the DAP jumper back to the Press: [user slot number] [new user code] #

If you inherit a property with a DK-9830 keypad and do not know the master code, you cannot enter programming mode. You must perform a hardware reset. To reset the master code to factory defaults: Disconnect the power supply from the keypad.

The Master Code is used to enter programming mode and is generally different from the user codes.